ไดเร็คบ๊อกซ์แบบติดผนัง Radial StageBug SB-5W, 5mm and RCA inputs with level control, Passive design, no power needed, Contractor-friendly screw terminal outputs, Transformer isolation to eliminate noise, Balanced left and right mic level output terminals
ราคาไม่รวมภาษีมูลค่าเพิ่ม…..
฿5,700.00
ไดเร็คบ๊อกซ์แบบติดผนัง Radial StageBug SB-5W, 5mm and RCA inputs with level control, Passive design, no power needed, Contractor-friendly screw terminal outputs, Transformer isolation to eliminate noise, Balanced left and right mic level output terminals
The StageBug SB5W provides a permanently mounted interface to connect consumer audio devices with installed pro audio systems. Front panel 3.5mm TRS and RCA connectors are provided for any stereo source and a fully variable level control makes volume adjustments easy. Inside, the SB5W employs dual transformers that convert the inputs to a low impedance balanced signal, and eliminate hum and buzz caused by ground loops.
Set & forget ground lift and mono switches are also included to further reduce noise and to sum the left and right channels together if needed. The outputs of the SB5W feature screw terminals with tie down points for tie-wraps to make installation fast, efficient and permanent.
Audio Circuit Type | Passive transformer isolated |
Frequency Response | 20 Hz to 20 kHz |
Dynamic Range | >120 dB |
Noise | -101 dBu |
Equivalent Input Noise | -98 dBu |
Maximum Input | +20 dBu |
Phase Deviation | 0° @ 100 Hz; -3° @ 50 Hz |
Total Harmonic Distortion | 0.002 % |
Input Impedance | Approx 10 KΩ with 100 KΩ Load |
Output Impedance | 5 kΩ |
Gain | -3 dB |
Output Clip Level | +17 dBu |
Controls | Controls: Level control adjustable passive trim Mono: Mixes left and right inputs Ground Lift: Disconnects audio ground at both terminals |
Inputs | 2x RCA 1x 1/8″ (3.5 mm) TRS stereo |
Outputs | Screw down terminals (- G +) |
Construction | 14-gauge steel chassis & outer shell |
Power | Passive, no power required |
Operating Conditions | For use in dry locations between 41 to 104°F (5 to 40°C) |
Installation | Only use in low voltage systems and enclosures |
Dimensions (L x W x H) | 2.42 x 1.62 x 4.24″ (61.4 x 41.1 x 107.7 mm) |
Weight | 0.5 lb (227 g) |